INVESTMENT material and cover the roof and the house party-type appearance. There are clay tile, concrete tile, there's also a metal (zinc), or mild steel. One thing the same variety from closing the roof is to have relief. However, different shapes, different, have a similar tile Textured usual, there is a surge.
Each type of closing the roof has a different way. Is a common way is to stick to the roof construction. For example, clay tile or concrete is generally installed on the roof of wood construction. Installation is not difficult. Enough to associate tile ring, then up the edge with another tile.
Installation of metal tile quite another. Usually tip use screw, nail, or a special lock.
Tile sold a lot of metal now made from a mixture of zinc and aluminum. Each sheet, one of them, measuring 80cm wide and 77cm long. Tile size can be installed quickly because the tide is equivalent to install eight clay tile array. How to install any easier. Place the tile on the ring that has been prepared, and then paste the drawing.
The lightweight steel roof tile, the larger size. Tile is more often used as a cover or roof of the factory buildings, though have also applied to stay at home. Installation of steel roof tile was easier because it is equipped with a special key. In addition, the size is fantastic, width 40.6 cm long and appropriate order, speed up the process of localization. Also leak out or absorp possibility.
The steps:
1. After the framework of the roof finished, do the installation for insulation wire nets (aluminum foil and glass wool). Insulation is placed double sided (two sides go back and forth). This is to muffle hot sun, the rain water noise.
2. Place holder lock type KL 65 on order gording roof insulation already installed. Lock holder. Use a drill as a power tool.
3. Place a sheet steel roof-wave light on the key holder before. Align and fix position. If you are fit, press the foot until it locks. How do the same for the next overlay roof.
4. Make the edge of the cover with images and forms that have been determined. Installation is done with the help of fastening and special electric drill.
5. Before the peak, the tip of the curved roof to the outside with a special bend tool. Bending angle 80 degrees. Bending this work as water entry because blow wind. Place the peak after the end of the roof bend neat.
6. Nok attached made metal scissors with a hole in the roof top of each wave. After the hole is finished, do the lock screw with a special cross-hose is installed by one wave. Nail using electric drill with the upright position so that the position of the screw is not italics. The remaining length of peak can be cut with metal scissors.
7. Use sealant gun connection to rooftop. Sizing is done on the rooftop and the bottom up. Paste pressed both ways. Once dry, the screw with an electric drill so that the connection is locked.
Metal roof : Like Door Lock Install
Labels: Exterior, Open Space