Tips for the home

Hanging doors is not so easy if you do not know a few tricks. Here I show you a simple way to hang on the door. First, we must adjust the size of the next door, which already exists.
Doors are available in various sizes. Producers are also what we in the trade, such as white, is a solid piece of the door, reducing its size. There are also companies that special in size, but can be expensive, since it is a certain size.
First, the measurement of the size of the door, ask your provider, if any. Size can be metric or imperial, possibly feet and inches or millimeters. The old door can be less than one population (standard size), it is a good thing, then, if this is for you.
Sometimes, with modern buildings, you realize you really are not very much to do, and hang the new door on the frame to adjust the size, because the frames and doors are designed specifically for your home when it was built.
In the old buildings are a problem, probably because the building collapsed at one point or another of the door or frame cockeyed slant. Personally, I have seen some of the 30-mm square, and only at the door widely, say, 900 mm or 800 mm.
If you have such a situation, first check that the door is desirable, it is. After installing a new door and the door shelves of old (if he) at the top and the old house as a template and mark around it. This is a very simple solution, if they are compatible with this situation.
Modern doors, sometimes with a central hole, so that they are easier on the joints. They are like a box of eggs in one solid piece of the door and run him hard. Cut away and you are in difficulties.
When you click on a new door to the room for another week, so you can acclimatise to the room because the door to the store until you bought it and adapt to their environment. I know there is only one door, but do not forget that this is the tree of life, to breathe again.
The next very important thing to find (most people do not know this), at the top or bottom of the door there is a stamp mark on the door, the designation of "LOCK" icon, where the next door is locked. The design of the door manufacturer, glue a block of wood with a lock. On the hinge of the door is about 20 mm screws on the hinge side. Above and below are the same thickness, if you have this piece can be cleaned and back to the staples and glue to dry. Away from the door lock in the same way as in the loop, but I have in front of the entire block of 300 mm in length, and it is essential that you have that right. Get it wrong and they face difficulties in ensuring the screws on the door itself, because only in a thin film in front of the door, it would be better to pull the door off and again as the door handles do not meet with the constant opening and closing.

Related Posts by Categories